Smart Technologies SMART Hub SE240 Installation And User Manual - page 23
17 |
CHAPTER 3
– CONFIGURING YOUR HUB
To configure network
management settings
1. Select
System > Settings
.
The
SMART Hub SE240
Settings
dialog box appears.
2. Select
Network and Conference > Management, Room Control
.
3. Select the
Enable remote management of SMART Hub SE240
check box to
enable your hub’s SNMP settings.
4. Select
Use the settings password as the SNMP (read/write strings
to use the
general settings password for the SNMP read/write strings.
OR
Select
Manually assign SNMP read/write strings
, and then type the appropriate
information (as supplied by your network administrator) in the following boxes to
manually assign the SNMP read/write strings:
–
Read community string
–
Write community string
–
Trap destination address
IMPORTANT
In SNMP, community strings are text strings that act as passwords. "Get"
requests are valid only if their community strings match the value in the
Read
community string
box, and "set" requests are valid only if their community
strings match the value in the
Write community string
box.
5. Type the IP address to which your hub should send traps (as supplied by your
network administrator) in the
Trap destination address
box.
NOTE
Traps are unsolicited, asynchronous events that devices such as your hub
generates to indicate status changes.
6. Press
Apply All
TIP
To fully utilize the SNMP features, download your hub’s Management Information
Base (MIB) files from
www.smarttech.com/SE240firmware
. SNMP management
software uses MIB files to interpret the information from the devices that it
monitors.