Smart Technologies SMART Hub SE240 Installation And User Manual - page 33
27 |
CHAPTER 3
– CONFIGURING YOUR HUB
System Information Commands
Configuring Language and General
System Settings
Your hub’s user interface is set to English by default. You can change the language to
one of the following:
You can view your hub’s system information, including the firmware version, Internet
Protocol (IP) address and Media Access and Control (MAC) address.
To set your hub’s user
interface language
1. Select
System > Settings
.
The
SMART Hub SE240
Settings
dialog box appears.
2. Press
System and Language
.
3. In the
Language
list, select your preferred language from the drop-down menu.
4. Press
Apply All
.
To view system
information
1. Select
System > Settings
.
The
SMART Hub SE240
Settings
dialog box appears.
2. Press
System and Language.
The system information appears.
Command
Description
get lamphrs
Requests the number of hours that the projector lamp has
been in use {from 0 to 3000}.
NOTE
This command only returns a value if your hub
is connected to a Unifi, UF or UX projector.
get syshrs
Requests the number of hours that the system has been
in use.
get ipaddr
Requests the IP address.
get macaddr
Requests the MAC address.
get fwver
Requests the firmware version.
• English
• French
• German
• Italian
• Spanish