SVS MINI 5 LIFT Installation Manual - page 11
7. MOUNTING THE PROJECTOR:
After checking the lift operation and all clearances, the projector can be installed. The projector can be
mounted in two ways: inverted or platform mounted.
– The projector can be attached to the lift
by using a #9 Mounting Bracket, which is
the actual connecting hardware between
the projector and the lift. The base box
of the #9 mounting bracket will need to
be bolted to the lift. On the SVS Mini 5
lift, the mount will be secured to the "U"
shape cross member (saddle of the lift).
The mount base should be
centered side to side with the lift
frame.
Figure 9.
– If the projector is non-invertible, it can be placed on a SVS #13 platform (metal shelf used to support
projector).
Note: All weight attached to the lift must be centered between the cables. Balance point of the projector
should be placed in line with cables with +/- 1" of difference.
8. CABLE MANAGEMENT:
The SVS Mini 5 Series lifts all feature cable retainers installed on the scissor extensions in the rear of the lift.
These retainers are used to keep cables and other cords securely out of the way during operation. It is not
suggested to attach the cables to the scissors of the lift as they could get repeatedly pinched when the lift
raises and lowers. To keep projector cords away from scissors, please attach cords as demonstrated in
figure 10.
Figure 10.
S V S M I N I 5 L I F T I N S T A L L A T I O N
P a g e 1 1 o f 1 3
BACK OF
VIDEO PROJECTOR
V I E W - A
VIDEO CABLE
WIRE TIE AROUND POWER CORD, AND VIDEO LINE
SCISSOR
OF PROJECTOR LIFT
VIEW FROM BACK
POWER CORD
WASHER
WIRE TIE AROUND EXTENSION, POWER CORD,
AND VIDEO LINE
EXTENSION
SCISSOR
(ENLARGED TO SHOW DETAIL)
V I E W - A
M O U N T
P R O J E C T O R