SVS MINI 5 LIFT Installation Manual - page 5
2. CONSIDERATIONS FOR THE PLACEMENT OF THE LIFT:
•
Before beginning the installation, check the dimensions of the projector to be mounted against the
available space within the lift. Be sure to include the lens or any accessories which may add to the
overall dimensions of the projector. Maximum dimensions that the Mini 5 lift can accommodate are
15" W (or 38.1 cm) x 23"D (58.42 cm) + lens extension if necessary – see figure 1 & 2.
Figure 1.
Figure 2.
•
Preliminary measurements should also be made to layout the orientation of the projector to the screen
and projector to lift. If the projector lens if offset, the lift position must be offset accordingly to align
the lift and the projector with the center of the screen.
3. LIFT SUPPORTING STRUCTURE:
The Mini 5 Lift can be mounted
from four ½" threaded rods
spaced at 23.75" Wide (60.32 cm)
x 23" Deep (58.42 cm) -as
shown in figure 3. The threaded
rods must be supported by a rigid
structure and should not extend
more than 2' (0.6m). If the length
of the rods exceed 2' (from the
support structure to the lift's top
mounting holes), cross bracing
should be installed between the
rods to increase the stability of the
installation -see figure 4.
Figure 3.
S V S M I N I 5 L I F T I N S T A L L A T I O N
P a g e 5 o f 1 3
15.0"
22.0"
15.5"
25.75"
M I N I 5 - 5
10.375"
23.0"
INSIDE DISTANCE
FOR PROJECTOR
ELECTRICAL
BOX
TO SCREEN
PROJECTOR BALANCE POINT
25.75"
23.75"
2.50"
34.0"
26.25"
23.0"
TO SCREEN
(INCLUDES 3" FOR CABLES)
MAX DEPTH
M
= .53" [13.5mm] DIA
.
M
M
M
MOUNTING HOLE