SVS MINI 5 LIFT Installation Manual - page 9
6. ELECTRICAL WIRING AND LIFT CONTROL:
Electrical Connections should be made at this time. The Mini 5 lift is controlled with a low voltage
24v/AC controller called the Key Switch Control Box.
This controller can be easily connected to
external controllers like Crestron, AMX etc.
SVS WALL PLATE
F i g u r e 7 .
H o w t o u s e t h e l o w v o l t a g e c o n t r o l l e r :
a. To lower the lift to the show position, turn the keyswitch to the "show" position and press the toggle
down. The lift will stop once the roller compresses the show microswitch. The service mode is used to
bypass the adjusted show position and to set the lift in a service mode, turn the keyswitch to the "service"
position and press the toggle switch down. When the lift reaches its down limits, the lift will stop.
b. To raise the lift back to a storage position, turn the keyswitch to "service" and press the toggle switch
up. The lift will stop once its top frame compresses the up limit switches.
Note: The "up" switch works in both "service" and "show" position on the key switch.
Important: when the lift is set in a service mode, the lift will lower until it has reached its down limit
switches. The toggle switch on the control plate needs to be pressed at all times to activate the lift. It is
designed as a safety feature (the lift can be stopped at any time). The key is an extra precaution as well:
when removed, the lift is secured. If an external controller is use, please make sure that no object is
standing in the lift path as it lowers to a service position.
S V S M I N I 5 L I F T I N S T A L L A T I O N
P a g e 9 o f 1 3
VIEW FROM BACK
(24vac)
+
-
(SERVICE)
C
2
1
GRN
BRN
UP
PUR
BLK
BLU
WHT
MOTOR
POWER ON
WHT
DOWN
SHOW-OFF-SERVICE
RP2 (CONNECTS TO RJ2)
YEL
(SHOW)
RED
WHT
ORN
BLK
GRN
RED
WHT
BLK
ORN
GRN
BRN
BRN
3
2
1
4
5
6
9
8
7
12
11
10
WALL PLATE CONTROLLER