1. DL manuals
  2. SVS
  3. Lifting Systems
  4. MINI 5 LIFT
  5. Installation Manual

SVS MINI 5 LIFT Installation Manual - Svs Mini 5 Lift

Summary of MINI 5 LIFT

  • Page 1

    Svs mini 5 lift installation manual svs, inc. Lifting your image 2513 jenks avenue tel: 850-522-4747 panama city fl 32405 fax: 850-522-4739 www.Svslifts.Com sales@svslifts.Com.

  • Page 2: Svs Mini 5 Lift

    Svs mini 5 lift installation instructions sections: 1: preliminary installation checks ----------------------------------------pg. 4 2: considerations for placement of the lift ------------------------------pg. 5 3: lift's supporting structure ---------------------------------------------pg. 5, 6 & ...

  • Page 3: Svs Mini 5 Lift

    Svs mini 5 lift general description: the svs mini 5 lift is designed to support small lcd/dlp projectors. This model is an ideal solution for residential or commercial a/v applications with restricted ceiling clearance since the projector is installed between the scissors. Features: maximum lowering...

  • Page 4

    Please read through all instructions (including accessory instructions) before proceeding. This lift is designed to be used with a remote control unit, either automatically or manually controlled and will function without any special training in the "show position". The lift is supplied with a key s...

  • Page 5

    2. Considerations for the placement of the lift: • before beginning the installation, check the dimensions of the projector to be mounted against the available space within the lift. Be sure to include the lens or any accessories which may add to the overall dimensions of the projector. Maximum dime...

  • Page 6

    Figure 4. If ceiling clearance allows, an "x-y" or a cross-supporting structure is strongly suggested (as shown in two following suggested supporting structures). This will allow front-to-back or side-to-side adjustments if the lift is found to still be slightly offset with the screen once it has be...

  • Page 7

    Svs mini 5 lift mounting on a flat ceiling figure 5b. Important note for concrete ceiling installations: when attaching the lift to a flat ceiling, svs suggests two (2) pieces of #p1000t unistrut (approx. 10' long -3.04 m), to be installed on the ceiling first. Proper spacing between the 2 pieces wi...

  • Page 8

    Important: if a #2 plenum shroud or a #12 decorative cover are to be installed with the mini 5 lift. Please read their installation instruction before proceeding. The supporting structure should also allow enough space to install the mounting hardware of the decorative cover and the plenum shroud. 4...

  • Page 9

    6. Electrical wiring and lift control: electrical connections should be made at this time. The mini 5 lift is controlled with a low voltage 24v/ac controller called the key switch control box. This controller can be easily connected to external controllers like crestron, amx etc. Svs wall plate f i ...

  • Page 10

    Lift specifications usa international voltage 110v/60hz 220v/50hz low voltage controller 24v/ac 24v/ac. Current draw 2.3 amps 2.3 amps/1.2 amps material steel/aluminum steel/aluminum power requirements: 110v/50-60hz -220v/50-60hz low voltage controller: supplied with the lift. 12 pin connector plug....

  • Page 11

    7. Mounting the projector: after checking the lift operation and all clearances, the projector can be installed. The projector can be mounted in two ways: inverted or platform mounted. – the projector can be attached to the lift by using a #9 mounting bracket, which is the actual connecting hardware...

  • Page 12

    9. Setting the show position: the show position is adjusted by loosening the thumb screw on the show microswitch bracket, located on the upper motor frame -as seen in figure 11: a. Operate the lift in a service mode and lower the lift to the desired show position. B. Loosen the thumb screw and slide...

  • Page 13

    Svs mini 5 lift warranty svs provides a limited warranty on all products to cover failures due to defects in materials or workmanship which occur during normal use. This limited warranty does not cover failures which result from accident, misuse, abuse, neglect, mishandling, misapplication, alterati...