SVS MINI 5 LIFT Installation Manual - page 7
SVS MINI 5 LIFT MOUNTING ON A FLAT CEILING
Figure 5b.
Important note for concrete ceiling installations: when attaching the lift to a flat ceiling, SVS suggests
two (2) pieces of #P1000T Unistrut (approx. 10' long -3.04 m), to be installed on the ceiling first. Proper
spacing between the 2 pieces will be based on the distance between the top four (4) mounting holes of the
lift (as shown in Figure 1) .
You should use at least four (4) ½" bolts and anchors evenly spaced our on each piece of Unistrut to
distribute the weight of the supporting structure. Attach ½" threaded rods to the Unistrut, using Unistrut
#P3010- ½"" channel nuts in the channel, along with a locking washer and nut below channel to lock into
place.
MOUNTING INSTALL FOR MINIMUM CLEARANCE
Figure 5c.
S V S M I N I 5 L I F T I N S T A L L A T I O N
P a g e 7 o f 1 3
ALWAYS FOLLOW THE LOCAL BUILDING
CODES. SVS RECOMMENDS ALL MOUNTING
HARDWARE BE RATED TO HANDLE 4 TIMES
THE WEIGHT OF THE PROJECTOR
AND LIFT OR WHICH EVER NUMBER
IS HIGHER.
X - UNISTRUT
USE 10'LENGTH WHEN
POSSIBLE ON EACH X AXIS
UNSTRUT CHANNEL NUT
P3010 WITH WASHER
AND RETAINING NUT.
8 PLCS.
.375" FOR MINI 4
AND LCD LIFTS
.50" ALL OTHER LIFTS
P1000T 2 PLCS.
2 PLCS.
Y - UNISTRUT P1000 T
1/2" THREADED
RODS 4 PLCS.
M
= MOUNTING HOLES
M
THREADED ROD, 4 PLCS
USE NO LESS THAN EIGHT 1/2"
MACHINE THREAD SHIELDS AND
BOLTS TO SECURE TO CEILING.
MOUNTING MATERIALS NOT SUPPLIED BY SVS, INC.
M
M
M
T O S C R E E N
FRONT VIEW
SIDE VIEW
23.75"
[ 6 0 3 m m ]
23.00" [584mm]
2.50" [64mm]
UNISTRUT
M = .53" [13.5mm] DIA
.
M
M
M
MOUNTING HOLE
TOP VIEW