Tait TM8200 mobiles User Manual - Removing The Control Head

Radio Installation

35

body. The numbers in the diagram on the previous page 

refer to the numbered steps below.

1. Plug the control head loom onto the control 

head connector.

2. Insert the bottom edge of the control head onto the 

two clips in the front of the radio chassis, then snap 

into place.

Removing the control head

Important: During this procedure, take care that the 

chassis seal is not damaged. Damage to this seal 

reduces environmental protection.

1. On the underside of the radio, insert a flat-bladed screw-

driver between the control head and the radio chassis 

seal, in either position 

 or 

.

Note: Insertion points 

 and 

 are indicated 

on the radio chassis by a dot-dash-dot 

pattern (•

–

•).

2. Use the screwdriver to lift the control head off the chassis 

clip, then repeat in the other position.

The control head can now be removed from the radio body.

1

2

1

2

1

2