Tait TM8200 mobiles User Manual - Tm8250 Connectors
Radio Installation
39
4. Position the radio in the U-bracket for best viewing angle,
then tighten the thumb screws.
Microphone clip (TM8255 radios only)
Install the microphone clip in the most convenient location
for the radio user. It must be within easy reach of the user,
but in such a position that the microphone PTT key cannot be
inadvertently activated or jammed on.
TM8250 connectors
The TM8250 control head has two RJ45 sockets for program-
ming, and a power on/off LED.
Note: The pins of the two programming connectors
are connected in parallel, so care needs to be taken
when connecting external devices to these connectors.
The pin allocations for these connectors are explained in the
following diagram and table.
programming
connector 1
programming
connector 2
LED
Pin Programming
connectors
Description
ON/OFF
hardware power on/software
power off
13.8V
unswitched 13.8V power supply
RX AUD
receive audio output
MIC AUD
microphone audio input
RS485-
RS485 compliant output