Talaris ntegra 177-0800 User Manual - page 17
Ntegra
Machine Overview
TP05413021 Interim
Page 9 of 56
Copyright © 2009 by Talaris Ltd., Basingstoke (UK)
2.6
Cleaning
Routine Cleaning
For optimum performance, cleaning should be performed once a week under
normal usage and more frequently under heavy usage. Rotate each part by hand
to clean its entire surface.
Cleaning is best accomplished using:
• A lint-free, non-abrasive cloth.
• A lint-free, non-abrasive cloth dampened with water.
• Soft bristled brush
Upper Section
Lift the Upper Cover latch to open the Ntegra Upper Section for cleaning.
Ntegra Upper Section
Clean the rubber gap rollers, idler rollers with a slightly damp cloth. You may use
a small amount of liquid soap on the cloth. Ensure all soap residue is removed
from the rollers. Allow to dry thoroughly before connecting the machine to the
mains electrical supply.
Clean the glass of the IR Array with a soft brush, then clean both the IR Array and
the UV Sensor with a damp lint-free cloth, followed by a dry lint-free cloth to finish.
Clean the magnetic detector heads carefully with a small soft brush. Avoid
applying pressure to the detector head, this may damage the head resulting in
loss of performance or an inability to function. If there is a build-up of dirt on the
Upper Cover
Latch
IR Array
UV
Gap Rollers
Magnetic Heads
Lower
Section
Latch
Sensor
Rollers
Lower
Section
Latch
Latch
Gap Rollers
Rollers
Magnetic Heads
IR Array
UV
Sensor
Upper Cover
Display