Talaris ntegra 177-0800 User Manual - page 53
Ntegra
Functions
TP05413021 Interim
Page 45 of 56
Copyright © 2009 by Talaris Ltd., Basingstoke (UK)
On pressing the ESC/CLR to exit and save, the selected language will be used.
5.1.8
Start Mode
Press the 8 key on the numeric keys to toggle between AUTO and MANUAL start
modes.
If the manual start mode has been selected, the Ntegra will only start a count
when the START/STOP ( ENTER ) key is pressed.
In manual start mode, pressing the START/STOP ( ENTER ) key during a count
will force the Ntegra to stop.
5.1.9
Counting Speed
This feature allows the User to set the Ntegra to a specific counting speed for
each counting mode, within the allowable speed range for the mode.
Ensure that the Ntegra is in the operating mode for which the speed is to be set.
Press the 9 key on the numeric keys to toggle through the available speeds for
the operating mode.
5.2
Supervisor menu 2/2
5.2.1
Screen Saver
This feature allows a screen saver, either the default image or a pre-loaded ‘user’
image, to be enabled, and to set the time delay between the last Ntegra activity,
either counting or a key press, to the screen saver image being displayed.
Counting Speeds
Operating
Mode
Available
Speeds
Operating
Mode
Available
Speeds
Count
1000 npm
Orient
1000 npm
1200 npm
1200 npm
1300 npm
Fit
600 npm
1500 npm
700 npm
Mix
1000 npm
800 npm
1200 npm
Serial
500 npm
Single
1000 npm
Bar
1000 npm
1200 npm
1200 npm
Face
1000 npm
1300 npm
1200 npm
1500 npm
Note:
Contact your local Talaris distributor for further information on creating
and installing a ‘user’ image.