Talaris ntegra 177-0800 User Manual - Process Instructions

Ntegra

Process Instructions

TP05413021 Interim

Page 17 of 56

Copyright © 2009 by Talaris Ltd., Basingstoke (UK)

4

Process Instructions

4.1

Piece Count

Piece count may be used to count notes that do not have currency data installed 

in the Ntegra.  

Piece count may performed either with or without a batch setting, however, if no 

batch is set, the count will stop when the stacker or reject pocket reaches full 

capacity.

Using the “UP” navigation key, set the Ntegra in the “Count” mode.

If required, press the BATCH key to enable the batch limit.  If a quantity other than 

the default batch limit is required, enter the batch limit using the numeric keys, 

followed by the ENTER key.

Select AUTO or MANUAL start mode.  

Place the notes to be counted on the input hopper.  In the AUTO mode, the 

Ntegra will start as soon as notes are placed on the input hopper.  With the Ntegra 

in the MANUAL mode, press the START/STOP key to commence the count.

The Ntegra will count the notes, and display the total.  

If the batch ( or reject pocket ) limit is reached, the Ntegra will stop.  Remove the 

notes from the full pocket.  If AUTO was selected, the Ntegra will re-start 

automatically.  If MANUAL was selected, press the START/STOP key to re-

commence the count.

Note:

In the COUNT mode, all detectors are disabled.