TANDBERG 880 MXP User Manual - Tandberg 880 Mxp
Questmark Ltd
- 2 -
Tel No: 0115 9467500
104 Derby Road, Long Eaton,
Fax No:0115 9467515
Notts, NG10 4LS
VC No:0115 9467502
Tandberg 880 MXP
User Guide
.
Storing a pre-set
• Moving the camera between people can be slow. Alternatively, you can pre-set camera views and move
between them.
• To set a new preset, press and hold the number key you want that particular camera position to be set at.
• It is possible to set upto 14 preset camera positions which you can toggle between during a call.
• To move to a particular preset during a call press and release that number key to activate your desired
camera position.
Far end camera control (only available in call and if far end system allows)
• Whilst in a call, press the menu button and select the move camera
icon. Press the up arrow and the Near End ‘tab’ will be highlighted in
orange.
• Press the right arrow and the highlight will move to the Far End ‘tab’.
You can now select the camera control icon and you will be able to
control the far end’s camera (pan/tilt/zoom) and utilise their pre-sets in
the same way as you would when controlling the Near End camera.
• To switch back to the Near End camera, select the near end tab using
the same method .
Adjusting the Volume
• To adjust the volume in a call, use the
key. Try to keep the volume level at between
10 and 12 to avoid echo and feedback.
• The position of the mic may well be affecting the volume of the call as it may be too close or too far away
from the people in the meeting.
• To turn off your microphone, press the mic off key