Teac HDR2500T User Manual - page 14

User’s Manua

l 

5

Learning Key   

The unit RCU has some learning keys at the upper part. The keys (except SET key) can be 

used to memorize corresponding key values of TV RCU. After learning, you can realize remote 

control for TV with the unit RCU. 

The recommended keys are POWER, TV/AV, VOL+ and VOL- of TV RCU. The TV/AV identi-

fiers vary with different types of TV RCU. 

Instructions: 

1.  Hold down the SET key on the unit’s RCU for about 2 seconds, 

the indicator status changes from low light to high light, then 

release the SET key. 

2.  Press a learning key on the unit’s RCU (such as TV POWER 

key), indicator flashes slowly. 

3.  Aim the TV RCU to “receiving window” of the unit’s RCU, and 

press the corresponding key on the TV RCU (such as POWER 

key) to learn. The indicator status changes from quick flashing 

to light up, which means the learning is successful. 

4. Repeat 

step 

2

 and 3 to set other learning keys. 

5.  After setting, press SET key to exit, and indicator is off. 

6.  If the operation fails, please try again according to above steps. 

Notes: 

•  During setting, put the two RCUs on the same horizontal surface and the space 

between them should be within 5cm. (Refer to above picture) 

•  If there is no operation in 10 seconds, the unit’s RCU will exit from learning mode 

automatically. 

•  You can operate the learning function many times, but only the last one will be 

saved. 

•  Some TV RCUs may not support this function.