Cet manuel contenit avertissements en englais y en franÇais f o r p r o f e s s i o n a l c o o k t o p s installation instructions models p24wk psc364gd psc364gl psc366 psc484gg psc486gd psc486gl psc484wk.
Important installation information table of contents warnings . ................................................................................... Below introduction ........................................................................................ 1 important installation information ..........
The thermador professional™ cooktops are avail- able in a number of sizes and configurations. Model p24wk is a 24"-wide wok unit featuring a power burner rated at 30,000 btu/hr. The 36"- wide models psc364gd, psc364gl, and psc366 feature four sealed burners and a griddle, four sealed burners and a g...
Caution (1) when connecting the unit to propane gas, make cer- tain the propane gas tank is equipped with its own high- pressure regulator in addi- tion to the pressure regula- tor supplied with this unit. The maximum gas pressure to this appliance is not to exceed 14.0 inches water column from the ...
Step 1: ventilation requirements it is strongly recommended that a suitable exhaust hood be in- stalled above the appliance. Downdraft ventilation should not be used. The table below indi- cates the thermador hoods, by model number, that are recom- mended for use with the 24" wok and 36" and 48" coo...
Step 2: cabinet preparation note: • if a solid side cabinet wall exists on one or both sides, you will need to notch the front corner of the cabinet to match the countertop notch and to allow clearance for the cooktop front (see detail a, figs. 3 and 4). • if a supporting deck is used, the sides or ...
Step 2: cabinet preparation ∆ as defined in the “national fuel gas code” (ansi z223.1, latest edition). 0" bottom 18" min . 12" both sides 0" sides counter sunk screws fig. 2 installing side supports (both sides) b b d 23-7/16" see detail a fig. 3 wall installation with countertop backsplash d see d...
Front flush with cabinets; minimum of 25-3/8" cabinet depth required. Step 2: cabinet preparation fig. 5 side view of cooktop fig. 7 flush to cabinet front * provide clearance for screws by in- creasing cutout height by 1/16" or by notching in the location of the three screws. Fig. 6 projecting from...
Detail b – see fig. 9, above suggested regulator installation installation options gas flow ➞ gas flow ➞ gas supply regulator make sure gas regulator is horizontal after installation installation option 1. From shut-off valve 3/4" nipple wall 3/4" flex adapter regulator 3/4" flex line 3/4" manifold ...
Step 3: unpacking, moving, placing & anchoring the cooktop 1. Remove the outer carton and packing material from the shipping base. Ensure that you have all cooktop components before proceeding. 2. Remove the top grate castings, burner caps and grill grate (if so equipped) to reduce unit weight. 3. L...
Step 4: gas requirements & hookup natural gas requirements: inlet connection: 3/4" n.P.T. (minimum 3/4" dia. Flex line.) supply pressure: 6" to 14" water column. Manifold pressure: 5" water column propane gas requirements: inlet connection: 3/4" n.P.T. (minimum 3/4" dia. Flex line.) supply pressure:...
Step 4: gas requirements & hookup, continued caution: when connecting unit to propane gas, make certain the propane gas tank is equipped with its own high pressure regulator in addi- tion to the pressure regulator supplied with the appliance. The pressure of the gas sup- plied to the appliance regul...
Step 5: electrical requirements, connection & grounding • always disconnect appliance electric supply cord from wall receptacle before servicing this appliance. • all cooktop models must be plugged into a mating 3- prong, grounding-type re- ceptacle. The receptacle must be connected to a properly gr...
The stainless steel surfaces may be cleaned by wiping with a damp soapy cloth. Any mild glass cleaner will remove fingerprints and smears. Follow all cleaning by rinsing with clear water. Wipe dry with a clean soft cloth to avoid water marks. For discolorations or deposits that persist, use a non-sc...
Final check list ❑ cooktop correctly posi- tioned and anchored in countertop recess. ❑ specified clearances main- tained to cabinet surfaces. ❑ unit level – front to back – side to side. ❑ burner caps positioned prop- erly on sealed burner bases. ❑ all packaging material re- moved. ❑ backguard attac...
Bsh home appliances corporation 5551 mcfadden avenue, huntington beach, ca 92649 • 800/735-4328 eco16847 • 5040002711 rev. C • © 2003 bsh home appliances corp. • litho u. S. A. 6/03 thermador reserves the right to change specifications or design without notice. Some models are certified for use in c...
