VAG-Navisystems NaviTouch Installation And Configuration Manual - page 16
15
3) Now you will have to adjust the screen’s image position, push on the “Settings” button, then push on the
“Screen” button, and finally on the “Adjust position” button, this way we will enter to the screen’s setting menu,
adjust it using the menu buttons. You can also use the “Adjust Size” button to adjust even more the screen's image.
4) Once you have adjusted image, you have to calibrate the touch screen again, push on “Settings”, then push on
“Touch Screen”, and repeat the steps for calibration process mentioned before.
Even if you do this changes and you can’t adjust the image as much as you want, you can use the multimedia
interface image setting menu. Now you can insert the maps SD Card to the GSP Box.
3.1 RESET:
If you RESET the GPS Box or the multimedia interface, repeat again the steps from the chapter 2.1, maybe, when you
perform a RESET on it, the language of the GPS Box could be changed, follow the next steps to config. it again to your
desired language.
1) Make a touch calibration of the GPS Box following the steps described before, now push the “Settings” button,
then push the “Usual Setup” button and select the language that you prefer.
The default settings of the “Adjust Size” menu are the next ones:
Horizontal 0 & Vertical 5.
The default settings of the “Brightness/color” menus are the next ones:
Brightness 18 & Color 12.
NOTE: Remember to do again a
calibration of the touch screen
after adjusting the image on the
screen.