VAG-Navisystems NaviTouch Installation And Configuration Manual - page 18
17
• If bars don’t rise, try to connect another GPS antenna, it may be that the connected one isn’t working
properly as it should.
• If you have tried different antennas, and the system is still not working, it could be that the problem is
located on the interface GPS Box.
* We recommend to perform the antenna installation on the A Pillar base of the vehicle, in the dark zone of the
vehicle’s front glass, because of this zone permits the GPS data signal reception. See the sample image below:
If you DON’T receive GPS signal with the antenna connected after performing the previous steps; follow next steps:
• Go back to the GPS Box Main Menu.
• Enter to “Navigation”, once you are in the Navigation Menu, push on the “Settings” button.
• Push the button with an arrow on it, that is in the right bottom of the screen.
• Push on “GPS”.
• Uncheck the “GPS Active” box.
• Push on “Auto. Detec.” and wait for the final of the process.
• The normal channels that may appear are: port 2 / Caud Baud 38400 and/ or port 0/ Cau Baud 9600
• Now, go back to the navigation menu and push on “Map”.
• Push on an antenna image (antenna and vehicle) in the bottom left part of the map’s screen.
• Push on GPS, and
wait for the necessary time until the system receives the satellite signal .
• If in the “Precisión” box, the precision is mid-high, then there is a good GPS reception and the system is
working properly.
GPS ANTENNA