VAG-Navisystems NaviTouch Installation And Configuration Manual - page 17
16
NOTE: If you change the position of the
RGB to AV Switch from the GPS Box
(in
RGB
default position) it will RESET,
then follow the steps described before to adjust the system again.
3.2 Maps SD card and GPS signal:
Once you have insert the Maps SD card, we will have to setup the route of the executable file (.exe), to do that,
follow the next steps:
1) Push on “Settings”, then in “Navigate Setup”, uncheck the auto initialization software option, and push on the
folder icon.
Once you have pressed the folder icon, you must search for the .exe file of the SD card, use the menu arrows to
move through it, and push “OK” button to confirm you selection, once you have done this; it will appear the selected
route, then push the “X” on the right top corner of the screen to go back to the Main Menu of the GPS Box.
2) Once you are in the Main Menu push on the “Navigation” icon to access to the SD card maps.
3.3 Checking the GPS signal:
* Perform these steps on a space with good GPS reception. Don't try to perform the steps with the vehicle inside
of a building or a garage
• Disconnect the GPS Box antenna.
• In the main menu push on “Settings”.
• Push on “GPS DATA”.
• Push on the third image starting at the top (graph bar).
•
Now connect the GPS antenna.
• Look how many bars rise when you have connected the antenna (wait for some time) from 3 to 5 bars
is a normal reception, from 7 to 8 it’s an excellent reception.