Valor 850 Installer And Owner Manual - page 10
General notes to read before fitting your heater.
If fitting the heater onto a reflective or shiny surface such as a hearth we
recommend that this surface does not extend further than 300mm from the fixing
plane (wall). Reflective or shiny surfaces that project further than 300mm may
reflect an image of the internal light source.
When the fuel effect is on, it will be possible to see reflected light and movement
behind the outlet louvre at the top of the heater.
Fitting the batteries to the Remote Control Handset.
The remote control handset uses 2 x 1.5V AAA type batteries. For longer battery life
use only alkaline batteries. To install the batteries, slide the cover down on the rear of
the handset and remove (See figure 6). The polarity of
the batteries is marked on the inside of the battery
compartment.
If the heater does not respond to the remote control
handset commands, it is likely that the batteries are
faulty or require replacement.
Fitting the mains cable.
The heater is supplied with a mains cable assembly
that should be connected to the heater prior to
installation. The heater connector is located at the rear
bottom left (See figure 7).
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2011.
Page 10
Figure 7. Fitting the mains cable
Figure 6.