Valor 850 Installer And Owner Manual - page 18
Page 18
©
Baxi Heating U.K. Limited 2011.
Fitting the firefront and ash pan (Petrus model only).
1. Remove the firefront from its packaging.
2. The rear of the firefront may be fitted with
hanging screws or they may be supplied in
the firefront packaging. Where they are not
already fitted insert them into the lower
holes on both sides of the firefront. The
distance between the firefront and the
underside of the screw heads should be
approximately 12mm. The screws can be
adjusted to obtain the required fit (See
figure 22).
3. Hang the firefront on the keyhole slots on
the heater.
4. Position the ash pan cover beneath the
firefront.
Fitting the firefront and ash pan
(Dream model only).
1. Remove the firefront from its packaging.
2. Locate the firefront.
3. Position the ash pan beneath the firefront.
11. OPERATING THE HEATER
Never cover the heater or obstruct the opening at the base of
the heater, this could cause overheating and consequent risk
of fire.
The appliance can be controlled by the manual control located
behind the ash pan cover on the lower right hand side of the
heater or by using the remote control handset.
The heat settings are quoted using a 240V ~ 50Hz supply.
Remote Control - What do the buttons do?
Pressing the red ‘ON/OFF’ button.
To activate the remote handset it is necessary to press the red
ON/OFF button (See figure 23). The status lamp on the heater will
turn red (See figure 24).
Figure 23.
Figure 22.
INSTALLER AND OWNER GUIDE