Valor 850 Installer And Owner Manual - page 11
The mains cable guides.
At the base of the heater you will find two electric cable guides, one each side of the
heater. If required, the cable guide on the right hand side (looking from the front of the
heater) can be removed and put in the rectangular slot in the centre rear of the
heater. For removal and fitting please see the following sections.
Removing the cable guide.
1. Before removing the cable guide please note
that the wider part of the cable guide is on the
outer edge of the base (See figure 8 - Item 1).
2. To remove the cable guide push and lift the tab
on the bottom. The bottom of the cable guide will
open (See figure 8 - Item 2).
3. Hold the bottom of the cable guide close to the
heater then gently pull the cable guide away from
the rectangular slot (See figure 8 - Item 3).
Fitting the cable guide.
When fitting the cable guide please remember that
the wider part of the cable guide has to be fitted
against the outer edge of the base (See figure 8 -
Item 1).
1. Gently pinch the sides of the cable guide (See
figure 8 - Item 4) and push the cable guide into the
required rectangular slot.
2. Place the electrical cable into the guides and
close the top of the cable guides.
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2011.
Page 11
Figure 8. Removing and
positioning the cable guide.
Item 1
Item 2
Item 3
Item 4