Valor 850 Installer And Owner Manual - page 17
Page 17
©
Baxi Heating U.K. Limited 2011.
10. FITTING THE FASCIA
Fitting the infill trim (Petrus model only).
1. Remove the infill trim from its packaging.
2. Locate the four tabs on the rear of the infill trim
into the four slotted holes in the heater (See figure
18).
Fitting the infill trim (Dream model only).
1. Remove the infill trim from its packaging.
2. Locate the infill trim as in figure 19 and secure in
place using two M5 x 8 screws supplied.
Fitting the fascia.
1. Remove the fascia from its packaging.
2. As supplied the fascia support brackets
may be flat against the heater body. Using a
suitable tool or gloved hand bend the
brackets as in figure 20.
3. Hold the fascia firmly and lift into place.
Locate the fascia hanging brackets into
those on top of the heater (See figure 21).
Lower the fascia into place and swing the
bottom of the fascia towards the heater.
4. Secure the fascia through the holes in the
lower side legs of the fascia using two
washers and two M4 x 25mm screws
supplied.
Figure 21.
(Heater may differ from that shown)
Figure 20. Fascia support brackets
Figure 19.
Figure 18.
INSTALLER AND OWNER GUIDE