Valor 850 Installer And Owner Manual - page 12
Securing the heater.
The heater must be secured into position to prevent it from being tipped over.
The following securing options are available:
Method A - Securing the heater with Screws.
Method B - Securing the heater with Wire.
Method C - Securing the heater using the Optional Spacer Frame (kit number
0582631).
Method D - Securing the heater using the Securing clamp.
If fitting the heater into a fireplace or surround opening, try the heater in the opening
to ensure that it will fit.
On Dream models, never hold the hood / canopy on the front of the heater when
lifting.
If fitting the heater onto a decorative hearth surface such as marble or tile it is
advisable to protect the hearth surface. Do not drag
the heater as the surface finish may be damaged.
Method A - Securing with screws.
Note - If fixing to marble it is recommended that
Method B - ‘Securing with wire’ is used. Drilling
marble without the correct tools and experience may
result in the marble cracking.
1. Place the heater into the fireplace or surround
opening. Make sure that the heater is in the middle
of the surround or fireplace.
2. There are two slotted holes in the top of the
heater and four holes in the side flanges (See figure
9). We recommend the use of two upper holes and
two lower holes. Mark through the required holes so
that their position is clear when the heater is
removed.
3. Remove the heater.
4. Drill an appropriate size hole in each of the
marked positions for the wall plugs supplied. Insert
wall plugs into the drilled holes.
5. Place the heater so that the holes are in line with the wall plugs in the fixing
surface.
6. Screw and secure the heater with four wood screws - (See figure 3).
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2011.
Page 12
Figure 9. Screw location
(Heater may differ from that
shown)