Valor accolade 806 Installer's And Owner's Manual - Page 8
INSTALLER’S AND OWNER’S GUIDE
Page 8
Figure 8.
Fitting the Front
Before fitting the front surround, make sure that
the compact fluorescent lamp is fitted into the
lamp holder and that the plastic shroud, (which is
fitted over the lamp) is rotated to give the
preferred colour effect
Locate the magnets onto the four metal tabs on
the rear of the front surround. Carefully place the
front surround onto the heater body. (See figure
8).
Fuel Effects
The heater can be used with or without the decorative glass pebbles, if required open the
polythene bag containing the loose glass pebbles and place them on the fuel support to
give the most pleasing effect. It is not necessary to use all the glass pebbles supplied.
IMPORTANT
The glass pebbles are for decorative use only. There is a Choke risk for young
children. Make sure that young children can not gain access to the glass pebbles.
OPERATING YOUR HEATER
Never cover the heater - there is a risk of fire if covered.
The heater is operated by three switches located below the canopy.
Switch 1 =
O
Main On – Off
In the On position only the fuel effect light operates
Switch 2 =
❙
1 kW fan heat setting and fuel effect
Switch 3 =
❙❙
2 kW fan heat setting and fuel effect
The switches are mechanically interlocked, so when switch 1 is turned off, all switches
turn off.