Veermount Technology TeleHawk 3 Installation Manual - Simple Guide to Operation
Veermount Technology
Tele
Hawk
3
Installation manual
Page
11
of
14 pages
5.
Simple guide to operation
Control panel
At the control panel follow the instructions on the display:
Basically enter the required
SUBSCRIBER
number followed by
CALL
.
Once the
SUBSCRIBER
is called the TeleHawk3 rings the programmed number for that
SUBSCRIBER
and waits for 30
seconds for an answer. Ringing tone will be heard at the panel. The display will show the
SUBSCRIBER
number that was
entered.
If call is not answered within a preset time (default 30 seconds) the call is cleared. If a second number is available for
the same
SUBSCRIBER
it then calls that number and again waits for 30 seconds before clearing the call. The time of
waiting for answer is programmable.
When the call is answered a 'bing bong' is heard to indicate the fact, and the display changes to say 'Press
CLR
to
terminate call'.
To enter a PIN number, key in
CALL
, then the code, then
CALL
again.
(PINs can be up to 6 digits). A 'pip-pip-pip-… '
sound sequence will indicate that the door is open. The display will also indicate when the door is open
If trades button is fitted, pressing it will automatically open the door (or gate) at times set by the time switch in the
Power & Termination Unit.
If a concierge button is fitted this will call the warden, security or other central point, associated with the telephone
number programmed in.
To cancel a call at any time, press
CLR
.
S
UBSCRIBER
At the
SUBSCRIBER
's phone the call is received and answered as normal. The 'bing bong' will also be heard indicating
the call is from the panel.
The
SUBSCRIBER
may open the door by entering 1* or open the gate by entering 2* (or as otherwise programmed).
Should he not wish to let the caller in he may press
#
to clear the call.
If a call is not cleared correctly the system has a default timeout of 4 minutes. This is a programmable time.
-ooo0ooo-
Ref: Docs/Manuals/TeleHawk3
Issue 2.0 December 06