Verex VeDVR User Manual - Image Menu
14
VeDVR User Guide
21-0421E rev1.1
11. Press Confirm to save the settings.
DST Bias
•
The “DST Bias” setting allows “fall back” and “spring forward” offsets other than the typical “60min” to be
configured. Example: in some regions of the world, the clock is adjusted by 30min instead of 60min.
•
DST bias can not be configured using the Remote Station software as of version 1.1.29 of the software.
Date
This is the system date. Using the “▲”, “▼” and the “◄”, “►” the system date can be set. The format is mm-dd-yyy.
Time
Using the “▲”, “▼” and the “◄”, “►” set the system time. The format is hh:mm:ss.
When any or all of the Display Menu selections are completed, “Confirm” must be pressed to save your changes.
Pressing “Cancel” will not save the changes.
Image Menu
Set the display properties for each camera, including display status, position and format.
Select Camera
Use the “▲”, “▼” to select the camera to set display properties for.
Camera Name
Define a name for each camera.
NOTE: the camera’s name cannot be copied.
1. Select
one
camera.
2. Highlight the Name edit box.
3. Press
“EDIT”.
4. Press “F3” on the DVR controls or or left click the mouse menu or “A” on the remote control for F3, to change the
number keypad to the desired function. (I.e. Number, Uppercase, Lowercase or Symbol).
5. Use the number keypad to type the camera name in.
6. The camera name can be a maximum of 32 characters.
7. Press “ENTER” to save the name and exit edit status.
Select the On Screen Camera Name Position
To prevent the camera name from being displayed, disable the check box beside the camera name edit box. NOTE:
When the camera name is not displayed, it is not recorded on a video.
The disabled symbol is “x”. If the check
box is enabled, the camera name can be entered. The Camera Name Position can be copied to any other camera.
1. Enable the check box on the right side of the camera name.
2. Highlight the “Position” button.
3. Press “ENTER” to enter into the camera name position adjustment screen.