Verint nextiva s17xxe series User Manual - Using The Encoders
2: Configuring and Installing the Device
14
Verint Video Solutions
11. Select the unknown device, then click Configure. In the Reconfigure unit?confirmation
window, click Yes.
The New Network Configuration window appears.
12. To use DHCP (Dynamic Host Configuration Protocol), check Use DHCP. Otherwise,
enter the IP address, subnet mask, and gateway of the device, as provided by your
network administrator.
For more information about DHCP, see page 27.
13. Click OK.
The device reboots with its new network configuration. It may take up to 30 seconds.
14. In the Units tab, click Discover.
The new S17XXe device appears.
15. Select the device, then click Configure.
16. Configure the serial port parameters to match those of the target equipment (for
instance, camera or PTZ keyboard).
For more information, refer to the SConfigurator User Guide.
The S17XXe initial configuration is now complete. You perform further configuration with
either SConfigurator or a video management software from Verint Video Solutions.
Using the Encoders
On the S1704e-AS, S1708e, S1708e-AS, and S1712e, the composite video signal of an
input is sent to two separate encoders. You can have the following scenarios with regards to
the encoder use:
Scenario
Encoder 1
Encoder 2
point-to-point
point-to-point
unused
video management software
view at rate A
record at rate B