Verint nextiva s17xxe series User Manual - page 30
2: Configuring and Installing the Device
20
Verint Video Solutions
System Status LED
The system status LED provides detailed information on the current state of the transmitter,
excluding video.
* At least one of them must be transferred to obtain the LED condition.
The following power-up conditions on the system status LED are abnormal:
LED not lit—Check the power supply and cabling. If power is available and the LED
stays off, call Verint Video Solutions customer service for assistance.
Steady red LED—There is an internal error that prevents the device from starting
normally. Power down the device, wait 30 seconds, then power it up. If the condition
persists, call Verint Video Solutions customer service.
Video Status LEDs
The video status LEDs have the following behavior:
Condition
Indication
Steady green for 12 sec.
The device is powering up.
Flashing red (1 sec. intervals) The IP address of the device is already assigned to another device on
the network.
Flashing green (3 sec.
intervals)
The firmware has started, but the device is not connected to the
network.
Flashing green (1 sec.
intervals)
The firmware has started, the device is connected to the network, but
no audio/serial* data is transmitted.
Flashing green (0.2 sec.
intervals)
The firmware has started, the device is connected to the network, and
audio/serial* data is transmitted.
Flashing green-red (1 sec.
intervals)
The device is undergoing a firmware update.
Flashing red (0.1 sec.
intervals)
The device is being identified.
Condition
Indication
Steady green
A video source is connected to the corresponding input but video is not
transmitted.
Flashing green (0.2 sec.
interval)
A video source is connected to the corresponding input and video is
transmitted.
Flashing red (0.2 sec.
interval)
No video source is detected but video is transmitted.
3 red blinks every 2 seconds No video source is detected and no video is transmitted.