Wacker Neuson 0008954 Operator's manual - page 18
Recommendations for compacting
T01091en.fm
18
6.
Recommendations for compacting
6.0.1
Condition of the ground
The maximum layer thickness depends on several factors such as the
condition of the ground/soil, the moisture, grading etc.
This is why it is not always possible to make precise
recommendations.
Recommendation: In certain cases, determine the maximum layer
thickness by conducting compacting tests and taking ground samples.
6.0.2
Compacting on a slope
The following points must be observed if you plan to compact inclined
surfaces (slopes, escarpments):
∗
Start at the bottom of a slope (slopes that can also be easily managed
in an upward direction can be safely travelled in a downward direction).
∗
The operator must never stand with their back facing the bottom.
∗
Do not exceed maximum tilt of 20°.
Working on slopes that exceed this tilt will cause the engine lubrication
system to fail and thus inevitably damage parts of the engine.
Incorrect !
Correct !