Wacker Neuson 0008954 Operator's manual - Maintenance
Manual is about: Vibrating plate.
BPU series
of
36
Maintenance
T01093en.fm
22
8.2
Checking engine oil level
f Place the machine upright on a flat surface.
f Remove any dirt around the oil level dipstick.
f Remove the oil level dipstick (1) and wipe it with a clean, lint-free cloth.
f Screw the oil level dipstick all the way back in and pull it out again.
f Check: The motor oil level must be between the lower and upper marks.
f If necessary, pour new engine oil into the opening (2) until the upper mark is
reached on the oil level dipstick (see chapter Technical data for oil type).
f Screw in the oil level dipstick and tighten it by hand.
w c _ g r 0 0 0 0 8 7
=
>
?
1
2