Wacker Neuson 0008954 Operator's manual - Maintenance
Maintenance
T01093en.fm
23
8.3
Changing the engine oil
Note:
The work area should be covered with a waterproof sheet to protect
the floor (protection of the environment).
f Place the machine upright on a flat surface.
f Bring the engine to a hand warm temperature, either by letting it cool down
or running it until it is warm.
f Switch off the engine.
f Remove any dirt around oil level dipstick (1) and secure oil drain hose
(near 3).
f Place a sufficiently large container under the oil drain plug to catch the used
oil.
f Remove the oil level dipstick and wipe it with a clean, lint-free cloth.
f For oil drainage, release oil drain hose and let the used oil drain out
completely.
Note:
Avoid spilling oil. Remove any spilled oil immediately.
f Refasten oil drain hose.
f Pour new engine oil into the opening (2) until the upper mark is reached on
the oil level dipstick.
In doing so, screw the oil level dipstick all the way back in and pull it out again
repeatedly.
See the chapter Technical data for oil quantity and oil type.
Note:
Avoid spilling oil. Remove any spilled oil immediately.
f Screw in the oil level dipstick and tighten it by hand.
Note:
Dispose of the used oil in accordance with the applicable regulations.
w c _ g r 0 0 0 0 8 7
=
>
?
1
2
3