Wacker Neuson 0008954 Operator's manual - Maintenance
Maintenance
T01093en.fm
27
8.9
Checking exciter oil level
f Place the machine upright on a flat surface.
f Remove any dirt around the filler hole.
f Open filler hole.
f Check: Oil level must reach the start of the thread of the filler hole.
f If necessary, fill exciter oil through the filler hole.
Note:
For easier filling, use a funnel.
f Close filler hole and use a torque wrench to tighten it to 100 Nm.
8.10 Changing exciter oil
Note:
The work area should be covered with a waterproof sheet to protect
the floor (protection of the environment).
f Bring the engine to a hand warm temperature, either by letting it cool down
or running it until it is warm.
f Switch off the engine.
f Remove any dirt around the filler hole.
f Tilt machine slightly and support it.
f Place a sufficiently large container under the oil drain plug to catch the used
oil.
Note:
Avoid spilling oil. Remove any spilled oil immediately.
f Open oil drain plug.
f Tilt machine and let used oil drain out completely.
f Place the machine upright on a flat surface.
f Fill with new exciter oil through the filler hole to the start of the thread.
For oil quantity see Technical Data.
f Screw the oil drain plug back in and use a torque wrench to tighten it to
100 Nm.
Note:
Dispose of the used oil in accordance with the applicable regulations.
WARNING
Danger through overturning.
If the machine overturns, it can cause severe injury such as crushing. Only use
suitable and tested hoisting gear and lifting tackle of sufficient lifting capacity.
Turn off machine in a stable position.