Wacker Neuson 1030L3 Operator's Manual - Safety Information
Safety information
SV00080en.fm
22
4.5.5
Before you start to work with the cut-off saw, check to see that is in
proper working order and in a safe operating condition!
In particular, check the following: Inspect the condition of the cutting
blade (replace immediately if the disc is cracked, bent or otherwise
damaged). Check that the disc is properly mounted, the protective
hood is locked in place, the belt guard is firmly attached, the V-belt is
properly tightened, the throttle lever moves unhindered and functions
correctly, the handles are clean and dry and the multifunction switch
works.
4.5.6
Do not start the cut-off saw until you have completely assembled and
tested it in operation. The cut-off saw must only be operated when it is
completely assembled!
4.6
Cutting blades
4.6.1
The protective hood must always be attached. Change the cutting
blade only when the engine has been turned off!
If you are using diamond-edged cutting blades, make sure you ob-
serve the attached rotational direction mark.
4.6.2
Cutting blades are only designed to cut materials on their edges. Never
use the side surfaces for grinding purposes as this can break the disc!
(10).
10
min. 5 m
(16 feet)
11