Wacker Neuson 1030L3 Operator's Manual - Safety Information
SV00080en.fm
31
Safety information
NOTE!
When cut, mortar, stone or concrete generate a great deal of fine dust.
To extend the service life of the cutting blade (cooling medium), to en-
able a better visual inspection and to prevent excessive dust formation,
wet cutting is preferred over dry cutting. Both sides of the cutting blade
must be sprayed evenly with water. You can find the right equipment
for every wet cutting application in the Wacker Neuson product range.
4.11.1 Before beginning the cutting process, remove objects such as stones,
nails, etc. from the cut area.
Notice: Make sure that you know where the electrical cable is!
The quick rotation of the cutting blade at the contact point tears the ma-
terial and throws it out of the cutting groove. As far from the cut as pos-
sible (behind it), swivel the protective hood down (23) to divert the
workpiece particles that have been cut away from the operator.
4.11.2 Mark the cutting line and grind a groove ca. 5 mm (0.2") deep along the
entire length of the workpiece at half throttle, which will guide the cut-
off saw exactly during the subsequent cutting process.
NOTE:
Using a guide cart (24) is recommended for long, straight cuts. It
makes guiding the cut-off saw in a straight pass easier and doesn't re-
quire as much effort.
23
24