Wacker Neuson 1030L3 Operator's Manual - Safety Information
Safety information
SV00080en.fm
26
4.7.8
Always support the workpiece such that the cut is under tensile
stress (16) so that the cutting blade is not pinched as cutting progress-
es.
4.7.9
When starting the cutting process, always move the cutting blade care-
fully toward the workpiece. Avoid uncontrolled movements.
4.7.10 Never cut through several workpieces at once! When cutting, make
sure that the tool does not contact other workpieces.
4.8
Work habits and methods
4.8.1
Before starting operation, check the work area for any hazards (elec-
trical cables, flammable materials). Clearly indicate the work area (e.g.
set up warning signs or barriers).
4.8.2
During operation, hold the cut-off saw tightly using the front and rear
handles. Never allow the cut-off saw to run unattended!
4.8.3
When possible, operate the cut-off saw with nominal spindle speed
(see "Technical data").
4.8.4
Only work in well-lit areas with good visibility. Be particularly careful re-
garding slippery or wet surfaces, ice and snow (slipping hazard).
4.8.5
Never work on an instable surface. Exercise caution with obstacles in
the work area that present a tripping hazard! Always ensure that you
are standing in a secure position.
4.8.6
Never cut above shoulder height (17).
16
17