Wacker Neuson BTS 1030L3 Operator's Manual - Safety Precautions
Safety precautions
SV00068GB
17
4.4
Fuels/Refuelling
4.4.1
Go to a safe, level place before refuelling. Never refuel while on
scaffolding, on heaps of material, or in similar places!
4.4.2
Switch off the engine before refuelling the Power Cut.
4.4.3
Do not smoke or work near open fires (6).
4.4.4
Let the engine cool down before refuelling.
4.4.5
Fuels can contain substances similar to solvents. Eyes and skin should
not come in contact with mineral oil products. Always wear protective
gloves when refuelling (not the regular work gloves!). Frequently clean
and change protective clothes. Do not breathe in fuel vapors.
Inhalation of fuel vapours can be hazardous to your health.
4.4.6
Do not spill fuel. If a spill occurs, clean off the cutt-off saw immediately.
Fuel should not come in contact with clothes. If your clothes have
come in contact with fuel, change them at once.
4.4.7
Ensure that no fuel runs into the soil (environmental protection). Use
an appropriate base.
4.4.8
Refuelling is not allowed in closed spaces. Fuel vapors will accumulate
near the floor (explosion hazard).
4.4.9
Make sure to firmly tighten the screw plug of the fuel tank.
4.4.10
Before starting the engine, move to a location at least 3 meters (10
feet) from where you fuelled the cut-off saw (7), but not within the
extended swing range of the cutting blades (direction of sparks).
4.4.11
Fuel cannot be stored for an unlimited period of time. Buy only as much
as will be consumed in the near future.
4.4.12
When making up the gasoline/oil mixture, always put the oil in the
mixing container first, and then the gasoline.
6
3 meters
(10 feet)
7