Wacker Neuson BTS 1030L3 Operator's Manual - Safety Precautions
Safety precautions
SV00068GB
29
4.11 Transport and storage
4.11.1
Always turn off the cut-off saw when transporting it or moving it
from place to place on a site (26).
4.11.2
Never carry or move the unit with the engine running or the blade
turning!
4.11.3
Carry the unit only by the tubular (middle) handle with the cutting blade
pointing behind you (26). Avoid touching the exhaust muffler (burn
hazard!).
4.11.4
When moving the cut-off saw over longer distances, use a
wheelbarrow or wagon.
4.11.5
When transporting the cut-off saw in a vehicle, make sure it is securely
positioned in such a way that no fuel can leak out. Always remove the
cutting blade before transporting the unit in a vehicle.
4.11.6
The cut-off saw should be stored safely in a dry place. It must not be
left outdoors! Always dismount the cutting blade before storage. Keep
the cut-off saw away from children.
4.11.7
Before long-term storage and before shipping the cut-off saw ,
follow the instructions in the chapter on “Periodic care and
maintenance“. ALWAYS empty the fuel tank and run the
carburetor dry.
4.11.8
When putting cutting bladess in storage, be careful to:
4.11.9
Clean and dry them well.
4.11.10 Store them lying down flat.
4.11.11 Avoid dampness, freezing temperatures, direct sunshine, high
temperatures and temperature fluctuations, as these can cause
breakage and splintering.
4.11.12 Always check new cutting blades or blades that have been in
storage to make sure that they are free of defects.
26