Wacker Neuson DPU 6055 Operator's Manual - page 15
T00782GB
13
TRANSPORT TO WORK SITE, RECOMMENDATIONS ON COMPACTION
Transport to work site
Conditions:
-
To transport the vibration plate, only use suitable lifting equipment with a minimum load-bearing capacity of
500 kg.
-
Always switch off engine before transporting the machine!
-
Only attach suitable tackle at the central lifting point (16) provided. The central lifting point is located exactly
above the centre of gravity of the machine. The central lifting point can be displaced rearwards (18), given
an application in which the height of the machine is of importance (torque wrench setting = 85 Nm).
-
During transport on the loading area of a vehicle, tie down the vibration plate using the lugs (17).
Note:
Also overve the regulations in safety instructions.
Recommendations on compaction
Ground conditions
The max. compaction depth depends on several factors relating to the ground condition, such as moisture,
grain distribution etc.
It is therefore not possible to specify exact.
Recommendation:
In each case determine the max. compaction depth with compaction tests and soil sam-
ples.
Compaction on slopes
The following points are to be observed when compacting on sloped surfaces (slopes, embankments):
*
Only approach gradients from the bottom (a gradient which can be easily overcome upwards, can also be
compacted downwards without any risk).
*
The operator must never stand in the direction of descent (see chapter “safety instructions“).
*
The max. gradient of 25
o
must not be exceeded.
☛
ATTENTION!
A tilt in excess of this angle could lead to a stopping of the engine due to the automatic
low oil shut-off system. A restarting of the engine can only take place after the valve lever
at the oil filter housing has been actuated once.
Right !
Wrong !