Wacker Neuson DPU 6055 Operator's Manual - page 23
T00796GB
21
OPERATION
Starting in cold weather
Always free the engine if the temperature is less than -5 ˚C (23 ˚F).
1. Push the throttle lever (8) to the full throttle position.
2. Turn decompression lever to any position in front of starting position „f“.
3. Crank the engine counter-clockwise with the safety start crank (24) as long as necessary until cranking
becomes easier (10 to 20 crank turns).
4. Press pin „d“ in for approx. 5 seconds.
5. Clean the area around the dosing device and then pull off the cover.
6. Fill the housing to the upper edge with low viscosity oil. Replace cover and press down with force. Exactly
two successive fillings are required.
7. Turn the decompression lever all the way to „f“.
8. Then start the engine immediately with the electric starter or by using the safety start crank.
d
f
e