Wacker Neuson DPU 6055 Operator's Manual - page 33
T00797GB
31
MAINTENANCE
Battery
Check acid level:
1. Remove battery cover.
2. Check acid level, if necessary top up with distilled water.
3. Secure battery cover.
☛
ATTENTION!
Before mounting the battery cover, make sure that the positive terminal cover is there!
Check the course of the degassing hose.
☛
ATTENTION!
Protect hands end eyes against the acid!
Note:
Only replace defective batteries with original Wacker batteries. Standard batteries are
not suitable for the high vibration loads.
4. When changing the battery:
Removal:
First disconnect negativ, then positive terminal of battery.
Assembly:
First connect positive, then negative terminal of battery.
When using starting sprays etc., see chapter operation.
Hydraulic control
Check oil level:
1. Move centre pole into vertical position.
2. Open filler bore (36).
3. Oil level must be at mark, if necesary top up with hydraulic oil
Fuchs Renolin MR 520.
4. Close filler bore (36).
Venting hydraulic control:
1. Remove apron (38) by undoing the screws (39).
2. Move centre pole into vertical position, move shift lever (6) right
into the reverse position, open filler bore (36).
3. Loosen connecting screw (37).
4. Slowly push the shift lever (6) into forward motion direction until
hydraulic oil emerges bubblefree at the connection screw.
5. Tighten connecting screw (37), mount apron (38).
6. If necessary, top up with Fuchs Renolin MR 520, seal filler bore (36).