Wacker Neuson DPU 6055 Operator's Manual - page 25
T00796GB
23
OPERATION
Starting with external battery etc.
Observe the following connection sequence when using an external battery to start the engine:
1. Connect one end of jumper cable to positive terminal of auxiliary battery.
2. Connect the other end of jumper cable to positive terminal of the vibro plate battery.
3. Now connect jumper cable clamp to negative terminal of the auxiliary battery.
4. The other end of the cable must be connected to the negative terminal of the vibratory plate’s battery.
5. Disconnect jumper cable in reserve order.
☛
ATTENTION!
Only 12 V batteries may be used. The use of e.g. a 24 V truck battery will lead to an
explosion of the vibro plate battery!
☛
ATTENTION!
Only use insulated jumper cables!
Forward and reverse motion
The engine speed can be infinitely varied on the throttle control lever (8).
The direction of travel is determinet with the shift lever (6).
Depending on the position of the shift lever (6), the vibration plate compacts in forward direction, at standstill
or in reverse direction.
The forward and reverse speeds can be varied by selecting intermediate positions of the shift lever (6) or the
machine can be employed for particularly intensive compaction at standstill.
Forwards
Standstill
Reverse