Wacker Neuson DPU 6055 Operator's Manual - page 28
T00797GB
26
MAINTENANCE
Engine oil and oil filter
Check oil level:
-
Remove dirt from the oil dip stick area. Check oil level on oil dipstick (19).
☛
ATTENTION! Place the machine in an horizontal (level) position and stop the engine before checking
the oil level.
-
If the oil level is too low, top up with HD brand oil SAE 10W-40 though the filler nozzle (21).
-
Pay attention to the max. level mark on the dip stick!
Replacing oil and oil filter:
1. Let engine warm up.
2. Take off the front cover plate.
3. Remove the oil hose from the support (spanner opening 19) and then hang the hose into an appropriate
container.
☛
ATTENTION!
Danger of scalding by hot oil!
Collect the used oil and dispose of it according to local regulations.
4. Let the oil drain completely. Lift the back end of the machine if necessary.
5. Replace oil filter.
6. Clean mesh insert carefully to avoid bending the wire netting.
☛
ATTENTION! Watch out for the ”TOP” marking on the oil filter!
7. Check and, if necessary, replace O-ring „k“.
8. Moisten thread and O-ring of the screwed sealing plug with a lubricant.
9. Fill up with engine oil until the max. marking of the dip stick is reached.
10.Check the oil level again after a short engine test run and top up if necessary.
11.Be sure to check that the screwed sealing plug does not leak.
12.Fasten the front cover plate.
k