Wacker Neuson RCE Operator's Manual - page 28
of
56
Operation
RCE
28
Operator’s manual
7.2
Adjusting the machine
Adjusting the stop screw
1. Return the movable knife completely into the original position. For this press
the ON/OFF switch.
2. Loosen jam nut.
3. Open the protective hood (only installed on some machine designs).
4. Place the workpiece on the fixed knife.
5. Set the stop screw so that the workpiece is perpendicular to the axis of the
machine.
6. Tighten the jam nut.
WARNING
Starting the machine.
Danger of injuries from uncontrolled starting of the machine.
f Remove the plug from the plug receptacle before all work on the machine.
Item
Designation
1
Movable knife
2
Jam nut
3
Stop screw
4
Fixed knife
5
Workpiece
Protective hood (without
illustration)