Waldorf FN8127E Installation And Operation Manual - page 14

12 

Operation

Controller Basic Programming Mode - FN8127EE and FN8224EE 

Models Only 

The following Parameters can be changed in Controller Basic Programming Mode:- 

 Timer 1 - Cook Time Settings. 

 Timer 2 - Cook Time Settings. 

 Timer 3 - Cook Time Settings. 

 Cooking Temperature Setting. 

 Keypad ‘Lock - Unlock’ (Programming the Password Protection). 

NOTE: 

 Each Timer Key on the control panel can be individually programmed with a different cook 

time. 

 The user cannot enter Basic Programming Mode whilst a timer is running.  An alarm will 

sound indicating the key press, but access to programming mode will be blocked. 

Entering the Controller Basic Settings 

1. 

To enter ‘Programming Mode’, press ‘ON / OFF’ key to turn ‘ON’ 

the control panel. 

2. 

Press Programme Key ‘P’ to access the parameter setting required. 

a. If ‘LoC’ is displayed, control panel is locked which will prevent 

any accidental change to the operating mode. 

b.  To access parameters, whilst ‘LoC’ is displayed on screen,  

enter the passcode ‘1 1 3 3’. 

Setting 

the 

Parameters 

1. 

To change the settings, press either      or      Key until the value 

required is shown on the display. 

2. 

Press Programme Key ‘P’ to confirm new value and the change will 

be accepted.  Display will step on to the next parameter. 

To Exit the Programming Mode. 

To exit Programming Mode, press and hold Programme Key ‘P’ for approximately 3 seconds, or do not 

press any key for 2 minutes.  The display will revert to ‘Idle Mode’. 

TIMER 1 

COOK TEMPERATURE 

SETTING 

KEYPAD  

‘LOCK’ - ‘UNLOCK’ 

Min 0.01  

Max 99.59 

Min 88°C  

Max 193°C  

If set to ‘LoC’, password is required 

to change any of these settings.   

Password is 1,1,3,3. 

TIMER 3 

TIMER 2 

Min 0.01  

Max 99.59 

Min 0.01  

Max 99.59