Waldorf FN8127E Installation And Operation Manual - page 9
7
Installation
Installation Requirements
NOTE: It is most important that this appliance is installed correctly and that operation is correct
before use. Installation shall comply with local electrical and health and safety
requirements.
Waldorf Deep Fryers are designed to provide years of satisfactory service, and correct installation is
essential to achieve the best performance, efficiency and trouble-free operation.
This appliance must be installed in accordance with National installation codes and in addition, in
accordance with relevant National / Local codes covering health and safety, electrical and fire safety.
Australia / New Zealand AS / NZS3000
- Wiring Rules.
United Kingdom:
BS 7671
- Requirements for Electrical Installations.
Installations must be carried out by qualified service persons only. Failure to install the
equipment to the relevant codes and manufacturers specifications shown in this section will
void the warranty.
Unpacking
Remove all packaging and transit protection from appliance including all protective plastic coating
from door outer panel and exterior stainless steel panels.
Check equipment and parts for damage. Report any damage immediately to carrier and distributor.
Report any deficiencies to distributor who supplied appliance.
Check available electrical supply is correct to as shown on rating plate on inside of access door.
Check the following parts have been supplied with appliance:
FN8127E / EE
FN8224E / EE
Baskets 2
2
Lid 1
1
Drain Extension
1
2
Location
1.
Any appliance requires adequate clearance and ventilation for optimum and trouble-free operation.
Minimum installation clearances shown below, are to be adhered to.
2.
Position the Deep Fryer in its approximate working position.
3.
Legs (rear rollers - optional) must always be fitted. Ensure the legs / rollers are securely attached.
Clearances
NOTE:
Only non-combustible materials can be used in close proximity to this appliance.
To allow easy operation, drainage and servicing of the appliance, a minimum of 600mm
clearance should be maintained at front of appliance.
Assembly
This model is delivered completely assembled. Ensure that the legs are securely attached.
NOTE:
This appliance is fitted with adjustable feet to enable it to be positioned securely and level
on uneven floors. This should be carried out on completion of gas connection. Refer to
'Gas Connection Section'.
The rear leg housings on this appliance can also be fitted with rear rollers to enable the
appliance to be easily moved for positioning and cleaning purposes. If desired, these
rollers are supplied in the packaging, with tappliance. See overleaf for fitting instructions.
Optional Accessories (Refer to Replacement Parts List)
Plinth Kit. For installation details, refer to the instructions supplied with each kit.
Combustible Surface
Non Combustible Surface
Left / Right Hand Side
50mm
0mm
Rear
25mm
0mm