Waldorf GP8121GE Installation And Operation Manual - page 10
8
Installation
Clearances
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
Assembly
This model is delivered completely assembled. Ensure that legs
are securely attached.
NOTE:
This appliance is fitted with adjustable legs to
enable it to be positioned securely and level on
uneven floors. This should be carried out on
completion of gas connection. Refer to 'Gas
Connection Section'.
This appliance can also be fitted with rear rollers to
enable appliance to be easily moved for
positioning and cleaning purposes. If desired,
these rollers are supplied in packaging, with
appliance. See below for fitting instructions.
Optional Accessories (Refer to Replacement Parts
List)
Plinth Kit. For installation details, refer to instructions
supplied with each kit.
Fitting Rear Rollers.
1.
Raise appliance from floor by approx. 75mm
using suitable lifting equipment (i.e.
Palletiser / Forklift) to allow rear adjustable
feet to be removed.
2.
Unscrew and remove both rear adjustable
feet from rear leg housings.
3.
Fit rear roller to rear leg housing and align
screw hole in side of rear leg housing with
threaded hole in rear roller.
4.
Secure rear roller to leg support with bolt
supplied and tighten bolt.
5.
Fit second roller and tighten.
6.
Lower appliance back to floor and adjust
front adjustable feet to level appliance.
Combustible Surface
Non Combustible Surface
Left / Right Hand Side
50mm
0mm
Rear
50mm
0mm
Fig 1
Appliance
Base
Adjustable
Foot
Rear Roller
Assy
Rear Leg
Housing
Roller
Locating Bolt
This appliance is for professional use and is only to be used by qualified
persons.
Only authorised service persons are to carry out installation, servicing or gas
conversion operations.
Caution