WANDERS STEALTH - SCHEMATICS Instructions For Use Intallation Manual - Setting The Display (From
13
Instructions for the use of remote control
Setting the display (from
°
C/24h to
°
F/12h and vice versa)
After connecting the battery (type: 9V block, quality recommendation: alkaline) or by
pressing AUTO and TIMER simultaneously the display will start to flash. While flashing
the appliance is in display-setting mode. By pressing the
AUTO button one changes from
°
C to
°
F and vice versa
. The display returns to manual mode after a few seconds, immediate
change is possible by pressing the TIMER button.
Setting the time
After connecting the battery (type: 9V block, quality recommendation: alkaline) or by
pressing
AUTO
and
TIMER
simultaneously the display will start to flash. To set the time
press (
) for hours and (
) for minutes. Then wait a few seconds or press
TIMER
to go back
to manual mode.
Setting the required temperature
Keep
AUTO
pressed until the display starts to flash, then using
(
) or (
)
set the
temperature. Wait or press
AUTO
to get to automatic-mode. A sensor in the transmitter
will measure the room temperature. The room temperature will be compared to the temperature
set. The receiver will receive a signal that will turn the motor of the gas valve
to adjust the height of the flames accordingly.
Setting the timer
Keep pressing
TIMER
until the
P1*
display flashes. Using the buttons (
) for hours and (
)
for minutes set the required ‘time on’ then press
TIMER
; when
P1
appears set the ‘time off’,
again press
TIMER
and set the times for program 2 (
P2*
and
P2
). Confirm by pressing
TIMER. Outside of the set times a
will appear in the display.
Using the different modes
Manual setting of the flame size (MAN)
Press (
) to light the fire (mainburner) or to increase the size of the flames, press (
) to
reduce the size of the flames and to set the stove to pilot light. When pressing these buttons a
send symbol will appear top left. If the vents have reached their limits the LED flashes on the
receiver.