WANDERS STEALTH - SCHEMATICS Instructions For Use Intallation Manual - Timer (Timer)
14
Temperature control (AUTO)
Press
AUTO
briefly. The set temperature will appear briefly and after that the room
temperature.
Timer (TIMER)
In time-mode during ‘ time on’ the temperature will be regulated just like in
AUTO
mode,
during the ‘ time off ’ the stove will be left on pilot light. To check the set temperatures press
AUTO
and then go back to time-mode.
During ‘ time off ’ the temperature is not controlled, thereby keeping the battery usage of the
sender to a minimum.
Pressing the (
) (
) buttons will always bring you back to manual control. We recommend
using the (
) button at all times before switching off the stove. This will inactivate the sender
and will minimize battery wastage.
Changing the batteries
When
BATT
appears top right or the LED on the receiver becomes darker it is time to change
the batteries.
Safety disconnection
Should the receiver not receive a signal for 2 hours the stove will be set to pilot light. The stove
will cut in again after receiving a signal.
Hints
Before switching on the AUTO or TIMER modes with (
) or (
) check the receptor
(when the send symbol appears in the sender, the LED has to light up in the receiver).
For temperature control the flame size will be adjusted during the time the motor turns.
This time depends on room size, stove capacity, battery strength etc. A micro processor
measures the temperature increase per time and corrects the motor turning time for the next
heating cycle to adjust the flame size according to the warmth required.
Is a low setting enough to heat the room the stove will switch between a low setting and off
after a few cycles. This ensures more even temperatures and longer burning times compared to
the simple on-off option.