WANDERS STEALTH - SCHEMATICS Instructions For Use Intallation Manual - Installation Manual
3
INSTALLATION MANUAL
Technical clues
Important:
Before you install and start using your gas fire, it is very important to read
these instructions thoroughly. Keep them in a safe place. During the
construction of our stoves we have not only paid our utmost attention to
quality and design, but also to maximum ease of use. We are therefore
confident that you will enjoy your stove for many years.
Your Wanders gas fire is built with a single burner system and the hearth has a
closed combustion room. Thanks to the use of a double walled (concentric)
tube and to natural draft, the necessary oxygen can be taken from outside the
building, while waste gases are blown out at the same time.
INSTALLATION REGULATIONS
Technical indications
-The Stealth is designed to be wall-mounted and should be installed by a
qualified fitter, in accordance with the national standards.
-
In case inflammable materials should be present behind the gas-fire, an
additional fireproof plate must be installed.
-Check if the stove was made fit for the desired gas type. This is indicated on
the license plate at the back of the stove.
-Check if the gas pressure is correct. This too is indicated on the license plate.
-Adjustments and other adaptations may only be carried out by an approved
fitter and in accordance with the applicable regulations.
-Respect the valid general gas installation regulations.