WANDERS STEALTH - SCHEMATICS Instructions For Use Intallation Manual - Attention
7
ATTENTION
:
you can also first install the tubes, before placing the stove. You
should then make use of a piece of telescopic tube with adaptable length, so that
the necessary length can be achieved easily.
WOODLOG SET
Take off the frame by removing the 4 screws in the left and right corners (see
scheme 3A). Next, take off the upper glass frame by removing the 4x8mm.screws.
Then remove the glass by pulling it out upwards; the lower glass frame can stay in
position, but the screws need to be unscrewed a bit. (see scheme 3b).
Now first cover the bottom of the burner with the supplied granules only with
natural gas (see scheme 2A).
Never place granules on the burner with propane (LPG)
Never place more granules on the burner than the supplied quantity!
Now place the logs. Be sure to put them in exactly the same position as shown in
the schemes 2B and 2C. Also make sure that the glass and the frame seal perfectly
before lightning the fire.
GAS CONNECTION
* Use an approved G3/8 inch stop tap with clutch in the gas tube
* The gas control unit is placed at the bottom on the front side , behind the lid
* ventilate the gas tube, before the stove is being connected.
* Avoid tension on the tap and gas tube; This may increase the risk of leakage.
* Check the connection on gas tightness.